Air sampling pump for PCM and TEM diagnosis of asbestos and fiber following AFNOR NFX 43050 standards.

Air sampling pump for asbestos and fiber monitoring. PCM sampling technique (2 liters/mn) and TEM sampling technique (7 liters/mn).
220Volts/50Hertz power supply (other tensions and frequencies available on request)

Simplicity

- Water-resistant, shock-resistant grey ABS case. Reinforced sub-frame with non-skid rubber bumpers and vibration absorbers.

- IP53-WR and IP54-FWR protection rates. Resistant to spraying water - 60°angle downward spray-

- Details: 395mm x 295mm x 330mm – Weight: 10kgs

Efficiency

- Quiet (< 40db), water-proof vacuum pump. Self-ventilated by sampled air.

- Nominal flow rate is 50liters/mn (without pressure drop)

Safety and control

- Micrometric cock with locking button.

- 8 digit flow meter display. Membrane filters system. Flow rate from 0.04m³/h to 6m³/h.

- 84-preset digital programmer operating 24/7, with a 10 year preset memory.

- Built-in flow meter (graduation from 0 to 10 liters)

- Translucent silicone tubing.

- 220 Volt auxiliary outlet

Optional equipment

- 12V/220V battery pack with 24h minimum run time. Weight: 36kgs.

- Tripod stand.

- C.A.th.I.A. sampling head with thoracic sampler.

IP54-FWR Version

Outer programmer cock and switch in this version.